- Hair loss
- Hair Extensions
Basic Steps for Safe Removal of your Hair System
Taking off your hair system is a bit tricky task and you may even damage it if you are not familiar with the right procedure. It is recommended to remove your hair unit before it starts falling off itself. This will help on cutting down the excessive gooiness while removal and cleaning. If you are looking for a safe and easy method of removing toupee or hairpiece then go through the following instructions.
- Adhesive Remover
- Paper Towels or Makeup Pads
Step 1: Apply adhesive remover
Apply some of your adhesive remover on the region of your hair unit that is secured to your head. Give few minutes to the solvent to absorb and break the bond before you move on to the next step.
Step 2: Start peeling hair unit from the backside
To prevent your front hairline from becoming damaged, it is recommended to remove your hair system from the backside to the front side. With the help of your fingers, feel around for the extreme back end of the hair unit. Now, spray your paper towel or makeup pad with isopropyl alcohol or Just Rite Positioning Spray until it is completely soaked.
If your hair system is full cap, then you must peel the sideburns before starting peeling from the backside.
Step 3: Peel up backside of hair unit till it is removed
One you have found the back edge of the unit; gently scarp it with your nail. All you have to do is to peel it enough so that you can grab it tightly with your fingers.
While peeling the hair unit from the backside, use your Just Rite Positioning Spray paper towel between the base bottom and your head. This enables you to easily peel off the unit be breaking the adhesive.
- Spray Remover – Spray some remover directly between the scalp and the base while peeling off the unit, after every few inches; spray some more adhesive spray remover.
Whichever method you go for, gradually remove the system a few inches at a time till it is completely off. If you use skin hair or polyurethane system make sure you do not pull very hard as it can stretch out the material.